:) You can test it first unassembled, just connect all wires and see that the PCB doesn't short circuit anywhere. That's it, your wheel should work fine now with GT4. Don't test it yet, wait until you have modified the pedals! However, it's better to just connect all cables and leave the case open for now, in case there is something still wrong. Now, the wheel itself should be ready, and in theory you could re-assemble it now. :) This is quite simple when done on the potentiometer side, just remove and re-insert the connector like this: The pinout page has all these pins explained as well.Īlso, the three pin cable going to the steering wheel potentiometer must be flipped, otherwise the steering will be reversed. Gray, light blue, pink, brown, white, purple, green, yellow, red, dark blue, black. The image is not very good, so here's the wires listed from left to right, when connector clips are facing up. Then insert the pins back into the connector in new order:
You can remove the ferrite bead if you like, it makes handling the cable a bit easier, and doesn't really affect anything. The pins come out quite easily, just bend the plastic clip a little with a small screwdriver.
0 kommentar(er)
